SPSATA001内部规范无振动冲击塑胶弹片式的
Product Specification For SATA Connector Rev. ECR Description Written/Date Checked/Date Approved/Date A N/A NEW Magic2010.11.18 Ti9onixin 创亿欣精密电子股份有限公司 TRONIXIN ELECTRONICS CO.LTD DOC. No. SP-SATA-00 Rev. A Page 2/8 Approved/Date Checked/Date Written/Date Magic 2010.11.18 SATA Connector Product Specification 1.0 Scope It applies to all SATA products of this standard. However, if there are any items which do not meet this standard, The entry of this product drawing in the case has priority over more than this standard. 2.0 Test Condition Un less other wise specified elsewhere, the following characteristics shall be defi ned 3.1 Temperature range 15C to 35C 3.2 Humidity range 45 to 75; 3.3 Atmospheric Pressure 650mm850mm of Hg But, it supposes that it has only a temperature and atmospheric pressure and that it is permitted to make a standard condition. 3.0 Rating 3.1 Voltage AC 5V[R.M.S] 3.2 Current 1.5A DC 25C 3.3 Rated temperature storage -4060C operating 050C normal 20C 4.0 Test s and Requirements 4.1 Examination of products Item Test Description Test s Requireme nt 4.1.1 Structure, dimension and appearance EIA364-18 Shall be con firmed with eyes in accordance with each drawing. Shall be con firmed by using proper measuring instruments. 1, The structure, the dimension, the material of the main components, and the surface finishing should meet the requirement of the drawings 2, There shall be no scratches, cracks, stains or warps that are detrimental to the function or the appearanee of the cormector Tionixin 创亿欣精密电子股份有限公司 TRONIXIN ELECTRONICS CO.LTD SATA Connector Product Specification DOC. No. SP-SATA-00 Rev. A Page 3/8 Approved/Date Checked/Date Written/Date Magic 2010.11.18 4.2 Electrical Perance Item Test Description Test s Requirement 4.2.1 Contact Resistance LLCR EIA 364-23 Subject mated contacts assembled in housing to 20 mV maximum open circuit at 100 mA maximum 1. Initially 30 milliohms Max. 2. Resistance increase 15 milliohms Max. after stress 4.2.2 Insulation Resistance EIA 364-21 After 500 VDC for 1 minute, measure the insulation resistance between the adjacent contacts of mated and unmated connector assemblies 1000 Mega ohms Minimum 4.2.3 Dielectric Withstanding Voltage EIA 364-20 B Test between adjacent contacts of mated and unmated connector assemblies The dielectric shall withstand 500 VAC for 1 minute sea level 4.2.4 Contact current ratingPower segment 1. Mount the connector to a test PCB 2. Wire power pins P2 and P3 in parallel for power 3. Wire ground pins P5 and P6 in parallel for return 4. Supply 6A total DC current to the power pins in parallel