HDMIAMSPEC测试规范要求

Product Specification For HDMI AM Connector Rev. ECR Descriptio n Written/Date Checked/Date Approved/Date A N/A NEW Magic2010.12.07 深圳市创亿欣电子有限公司 TRONIXIN ELECTRONICS CO.LTD DOC. No. CSP-HDMIAF-01 Rev. A Page 2/7 Approved/Date Checked/Date Written/Date Magic 2010.12.07 HDMI AM Connector Product Specification 1.0 Scope It applies to all HDMI AM CONN products of this standard. However, if there are any items which do not meet this standard, The entry of this product drawing in the case has priority over more than this standard. 2.0 Test Condition Un less other wise specified elsewhere, the followi ng characteristics shall be defined 3.1 Temperature range 15C to 35C 3.2 Humidity range 45 to 75; 3.3 Atmospheric Pressure 650mm850mm of Hg But, it supposes that it has only a 怕mperature and atmospheric pressure and that it is permitted to make a standard condition. 3.0 Rating 3.1 Voltage AC 5V[R.M.S] 3.2 Current 1.5A DC 25C 3.3 Rated 怕mperature storage -40〜60C operating 050C normal 20C 4.0 Test s and Requirements 4.1 Exami nation of products Item Test Description Test s Requireme nt 4.1.1 Structure, dimension and appearanee EIA 364-18 Shall be confirmed with eyes in accordance with each drawing. Shall be confirmed by using proper measuring instruments. 1, The structure, the dimension, the material of the main comp on ents, and the surface finishing should meet the requirement of the drawi ngs 2, There shall be no scratches, cracks, stains or warps that are detrimental to the function or the appearance of the connector ri9onixin 深圳市创亿欣电子有限公司 TRONIXIN ELECTRONICS CO.LTD HDMI AM Connector Product Specification DOC. No. CSP-HDMIAF-01 Rev. A Page 3/7 Approved/Date Checked/Date Written/Date Magic 2010.12.07 4.2 Electrical Perance Item Test Description Test s Requireme nt 4.2.1 Contact Resistance LLCR EIA 364-06B Mated connectors Contact measure by dry circuit, 20 m Volts maximum. 10mA. Shell measured by open circuit, 5Volts maximum, 100mA. Con tact 1. Initially 40 milliohms Max. Shell 1. Initially 50 milliohms Max. 4.2.2 Insulation Resistance EIA 364-21C Un mated conn ectors, apply 500Volts DC between adjacent terminal or ground. Mated connectors, apply 150Volts DC between adjacent terminal or ground. Un mated 100 Mega ohms Minimum Mated 10 Mega ohms Minimum 4.2.3 Dielectric Withstanding Voltage EIA 364-20C A Un mated cormectors, apply 500 V AC RMS between adjacent terminal or ground. Mated connector, apply 300V AC RMS between adjacent terminal or ground. No Breakdown. 4.2.4 Con tact curre nt rati ng EIA 364-70A Initial ambient temperature55 C Maximum. After temperature chan